HOME Page > Product Area > ArtiStick-Gen-0 : Roll Your Own

ArtiStick-Gen-0 : Roll Your Own

Artistic Gen-0 =

  Raspberry Pi-0W 
+ Raspbian OS 
+ DrizzleTV SW 
+ LefBank-specific Prototype Code (code name 'potato' )

DrizzleTV Software - Developed by DRZL. It does one-way synch to the HDMI port and does NOT work via the USB as needed by TLB
Potato as mentioned above - Som is funding to get this done for trial at up to 5 accounts. Hopefully by December.

#### NOTE:   You will not need a soldering iron.
#### But you WILL need a screwdriver that can handle the small screws of the FLIRC case (#2 on the list below)

Casey’s Wonderfull Instructions HERE

Drizzle-TV - UnPOTATO Bringup Instructions

List of materials: You will need…

A Raspberry Pi Zero W or WH - I recommend the W version. The WH just comes with a header which we do not plan to use. Either will work.

You can find out where to buy from here - https://www.raspberrypi.org/products/raspberry-pi-zero-w/?resellerType=home
- I usaually get it from Adafruit to patronize the makers - https://www.adafruit.com/product/3400
- Amazon link for Pi Zero W

The FLIRC Pi Zero case (link for Amazon)
Couple of high-speed USB cables. Make sure that they are not ‘charge-only’ cable. They should say “high-speed sync cable” like these
High-speed micro-sd cards. I recommend the Sandisk ultra cards for now. Note that the Gen-0 system may lose microSD cards due to power cycling. So you can buy 16GB cards for testing initially. Or you can buy 32GB cards. I recommend buyint at least two or three cards. These cards listed on Amazon are good.

[Optional]

You can get a mini-to regular HDMI cable. We do not plan to use them at this time. I recommend a 2-pack as I always seem to lose one These on Amazon look good

I do not recommend getting more than one or two sets until we test the software out a bit.